Swapping Out Gauge Pack - Toyota Yaris Forums

mikenacarato · 07-15-2009, 10:34 PM

i got an 09 cluster. there were no problems installing it at all, it was very easy and took about 10 mins or less and you only need a phillips head screwdriver.. ill take a pic later tonight for you guys and post a pic of the box with the P/N.

CTScott · 07-15-2009, 10:49 PM

Quote:

Originally Posted by mikenacarato

i got an 09 cluster. there were no problems installing it at all, it was very easy and took about 10 mins or less and you only need a phillips head screwdriver.. ill take a pic later tonight for you guys and post a pic of the box with the P/N.

Interesting. The 09 service manual doesn't mention anything about reprogramming. In the replacement procedure it does mention disconnecting the battery (but then again it does for replacing anything electrical).

You may want to try for the heck of it disconnecting the negative battery cable for a couple of minutes to see if perhaps on a cold boot the ECM and the combination meter do some type of a sync.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY Oil Pressure Gauge Install	LtNoogie	DIY / Maintenance / Service	13	11-20-2009 05:13 PM
A-pillar gauge pod	Tonavi	Cosmetic Modifications (Exterior/Interior)	26	02-26-2009 08:35 AM
Yaris safety pack - where is it located?	signs	General Yaris / Vitz Discussion	5	02-22-2009 07:43 AM
A-Pillar gauge pods that can fit tweeters?	IsLNdbOi	In Car Entertainment + Electronics (audio / video / alarm)	9	11-23-2008 03:25 PM
Gauge Pod for Liftback?	eight_heads	General Yaris / Vitz Discussion	2	06-07-2007 11:41 AM

07-15-2009, 10:34 PM	#1
mikenacarato SIPNDEW View User's Garage Drives: 15 STI Join Date: Oct 2008 Location: Brentwood, TN Posts: 2,281	i got an 09 cluster. there were no problems installing it at all, it was very easy and took about 10 mins or less and you only need a phillips head screwdriver.. ill take a pic later tonight for you guys and post a pic of the box with the P/N.