 |
 |
|
|
|
|
11-22-2010, 06:16 PM
|
#1 |
  Drives: 3-door hatch Join Date: Oct 2010
Location: Los Angeles
Posts: 519
|
Depending on how much clearance you need, an alternate technique I've read about is shaving the lip. If you only need a few millimeters of clearance, you can cut away the inner lip up to the spot welds. No damage tothe paint and you don't risk breaking or weakening the spot welds. More info at the My.IS (IS300) forums...
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tamago's guide to ultimate yaris handling | Tamago | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 99 | 01-25-2026 12:51 PM |
| Ignition vs. Roll start? | Alypuppy | Fuel Economy Forum | 53 | 05-18-2010 10:51 PM |
| Roll center adjuster | d1nzfe | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 19 | 05-16-2010 04:59 PM |
| solid torsion bar bushings... the best rear anti roll upgrade | turboyaris | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 28 | 12-05-2008 11:37 PM |
| Rolling Fenders | slvryaris | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 13 | 08-28-2006 04:45 PM |
Hybrid Mode
