Flashing Third Brake Light with DIY

[Lil Abner]

It looks like you can choose 5 or 10 flashes, then the light stays on solid. So yes, you would have to take your foot off the brake, and re-apply to get it to flash 5/10 times again. But if you turn on the 7 second thing, it would flash until after 7 seconds. Make sense?

[Meteorite_Marty]

Installed mine tonight using the original DIY, inside the driver side upper trunk panel (where the rear seat belt runs into).

Easy to pop off the panels, just be careful you don't lose any of those white plastic snap pins, or else you'll be dismantling the lower part of the trunk panels to find them (guilty as charged!).

Works perfectly, and DIY is 100% accurate information.

I really like the look. The delay is best for me since I get stuck in city traffic a lot and don't want it blinking constantly.

[brendan]

Originally Posted by Lil Abner

It looks like you can choose 5 or 10 flashes, then the light stays on solid. So yes, you would have to take your foot off the brake, and re-apply to get it to flash 5/10 times again. But if you turn on the 7 second thing, it would flash until after 7 seconds. Make sense?

Yeah that is how I see it too, but mine flashes 10 times,then solid, then wait for 7 seconds, then flashes again, but both thee jumpers are on, so it must flash every time you apply the brake ? but mine does'nt