Idler pulley for Blitz?? - Toyota Yaris Forums

07stlYaris · 10-09-2014, 09:43 AM

Noticed the bearing is clipped in. I'll try the bearing route. Any thoughts on the need for the ridges on both sides of the pulley? If I do replace the pulley, I doubt too many aftermarket or OEM for other vehicles will have those.

CTScott · 10-09-2014, 10:01 AM

Quote:

Originally Posted by 07stlYaris

Noticed the bearing is clipped in. I'll try the bearing route. Any thoughts on the need for the ridges on both sides of the pulley? If I do replace the pulley, I doubt too many aftermarket or OEM for other vehicles will have those.

That's a good question. I would think that the ridges should not be necessary, since the water pump pulley not just doesn't have them, but actually has a rounded edge.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DC header, AEM cai and MI lightweight crank pulley install	aspro	Performance Modifications	7	09-02-2014 06:57 AM
Explain: NST Underdrive & MI pulley	evo165	Performance Modifications	14	01-08-2014 02:18 AM
FS: NST 20% Overdrive Alternator Pulley	MGargano	Items for Sale by private party	12	06-05-2011 11:06 AM
FS: 2009 Alternator & Overdrive Alt. Pulley	MGargano	Items for Sale by private party	9	10-28-2010 07:42 AM
NEW GROUP BUY: NST WP-Lite & ALT-Lite Pulley Kit (NonStopTuning)	NonStopTuning	NonStopTuning	266	09-29-2007 02:51 AM

10-09-2014, 09:43 AM	#1
07stlYaris If Its Not Blown It Sucks View User's Garage Drives: 07 Yaris LB Meteorite Join Date: Nov 2011 Location: STL Posts: 117	Noticed the bearing is clipped in. I'll try the bearing route. Any thoughts on the need for the ridges on both sides of the pulley? If I do replace the pulley, I doubt too many aftermarket or OEM for other vehicles will have those.