 |
 |
|
|
12-23-2015, 09:22 PM
|
#18 |
  Drives: 2007 yaris 3 door Join Date: Sep 2015
Location: Denver, Colorado
Posts: 1,000
|
I have finally finished.twas' a pain in the ass. it's probably just best to buy one.
this is where it'll go...duh I didn't think about the o ring, and it would be difficult to do without the proper tools. I had a tool made to cut the o ring, but it could be done with a hole saw if you were careful. cut it first, then cut the bore. it wasn't too bad I guess... |
|
|
| Tags |
| intake, spacer, throttle body |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Carbon build up in the throttle body | Sedan | DIY / Maintenance / Service | 18 | 11-16-2013 12:44 AM |
| Throttle Body spacer? | jekqmb | Performance Modifications | 2 | 10-05-2011 12:02 AM |
| FS- 1ZZ Throttle Body, Spacer, NST SSK | MGargano | Items for Sale by private party | 9 | 09-01-2010 09:48 PM |
| For Sale: 1ZZ Throttle Body and 0.25" aluminum wheel spacers | m911gt | Items for Sale by private party | 6 | 04-25-2009 09:52 PM |
| Toyota Throttle Body Spacer: the Best Fuel-Saving Device | davidmills | Performance Modifications | 1 | 07-02-2007 12:38 AM |
Threaded Mode