Changed cluster have some questions?

[David C]

Originally Posted by B.B._07

There is a procedure to reset or turn off the ABS light by shorting a couple pins in the OBD2 port under the dash with a paper clip. In your case it may not work since you're car doesn't have abs and the dash might be programmed to turn the ABS light on by default if the signal is missing. But it's worth a shot.



This is the same procedure for the Yaris:

https://www.youtube.com/watch?v=PD1V6pv2ej0

How long has this fix been around ?? I have a '07 HB auto with ABS that the light is on due to a faulty sensor or whatever else problem that cause the ABS to disengage and it's annoying to have it on. So far it's the first time in a year that I've seen a way to reset that light without clearing and fixing the fault.

The two steps are to jump the pins and press the brake 8 times in 5 seconds then you can remove the jumper and its done ?


Envoyé de mon iPhone en utilisant Tapatalk

[B.B._07]

Originally Posted by David C

How long has this fix been around ?? I have a '07 HB auto with ABS that the light is on due to a faulty sensor or whatever else problem that cause the ABS to disengage and it's annoying to have it on. So far it's the first time in a year that I've seen a way to reset that light without clearing and fixing the fault.

The two steps are to jump the pins and press the brake 8 times in 5 seconds then you can remove the jumper and its done ?


Envoyé de mon iPhone en utilisant Tapatalk

The procedure is from the factory service manual and has been used by Toyota since at least the early 00's. Here's the procedure:

1. Jump terminals 4 and 13 of the OBD2 port
2. Turn ignition to ON (not running)
3. Press brake pedal 8 or more times within 5 seconds
4. Remove jumper wire or paper clip
5. Turn off ignition

This will clear the light but if the fault is still present in the ABS system the light will come back on eventually. There's also a procedure to read the ABS fault codes which the same as the clearing one except without the brake pressing part. After you jump the terminals and turn the ignition to ON the ABS light will blink in a pattern to indicate the code(s).