Stuck on my install, advice?

[CTScott]

How about just bending the tabs down on the bracket? That would gain about 5 cm.

[FEINT]

Originally Posted by CTScott

How about just bending the tabs down on the bracket? That would gain about 5 cm.

Originally Posted by m911gt

has anyone checked to see how the bracket is mounted to the floor of the car? I don't see why Toyota would weld a jack bracket in place, it may just be bolted in.

Thinking of doing that before cutting.

I checked that, its not bolted in. Its welded in. But its not hard hard metal. So going to try bending the brackets first then, cutting if that doesn't work.

Originally Posted by talnlnky

There is no such thing as "under feeding" when talking about amps & speakers.

That sub would be fine with 250ish watts... but... you most likely would want a bit more umph.

Personally... I'd bridge that 4 channel to run those Focal's and remove that mounting bracket even if it meant having to pay somebody $50 to cut it off just so I could run that 1500 to the IDMAX

Thanks. That would be ideal solution having the 4 channel bridged on the Focals and Mono on the iDMax.

Originally Posted by Yarisugi

Does the amp fit in the front pull tray? I think that would be the best place to put it.

Doesn't fit, its too large. Thanks for the idea though.


Thanks everybody. Will try bending, if that doesn't work. Bring on the angle grinder.!! My 2 week old vitz is going to get the AXE! :)