Looking at seats...

[MGargano]

Originally Posted by CTScott

I am measuring between the center wire (which is the signal output) and a chassis ground. I am using a needle probe, which is a very thin, sharp probe. With the waterproof connector, I am sticking it into the rubber seal around the wire.

Ok, I'll definitely give this another try tomorrow. I don't have work so I should have plenty of time to mess around.

Out of curiosity, based on what you see so far, does it look possible to turn the airbag (and seat belt light/chime) on and off with a toggle switch? Or will we have to rig something using the OEM sensors?

[CTScott]

Originally Posted by MGargano

Ok, I'll definitely give this another try tomorrow. I don't have work so I should have plenty of time to mess around.

Out of curiosity, based on what you see so far, does it look possible to turn the airbag (and seat belt light/chime) on and off with a toggle switch? Or will we have to rig something using the OEM sensors?

I'm not sure yet. Tomorrow morning I'll take a look at the signal output with an oscilloscope.