Help with Fog Lights!! (I HATE WIRES!) - Toyota Yaris Forums

joshpjost · 01-02-2010, 01:04 AM

Thanks for the detailed response. To clarify: My switch is of configuration 1. The black wire is ground, because it has a eyelet, so I grounded it near the specified bolt near the clutch. According to your instructions, this black wire, (pin 1) should go to Conn D20 -Pin 2? For manual transmissions, is this Conn just laying near the stick below the console?

Also, according to your instructions, it appears that I have the same configuration minus the ground. I have the red wire tapped into pin 4 of Conn D4 and the yellow wire tapped into Pin 3 - Conn D4. Would you agree that the misplacement of the black wire would cause my problem?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY (08' USDM Liftback): ESUSE Fog Light Install v2.0	goku87	DIY / Maintenance / Service	127	02-19-2023 08:01 PM
Sedan Fog Lights, few questions!(where to get) ( make into HID Fog Lights!!!)	Lafiro	Cosmetic Modifications (Exterior/Interior)	2	06-12-2009 04:56 PM
Disabled DRLs and Factory fog lights	DARKYARIS	DIY / Maintenance / Service	21	05-01-2007 06:32 PM
can i / where to get factory switch for aftermarket fog lights? and exhaust tip q.	fantabulousbaby	Cosmetic Modifications (Exterior/Interior)	22	08-29-2006 02:13 PM
Fog lights for S sedans (US version)	paeko73	General Yaris / Vitz Discussion	11	07-03-2006 12:38 AM

01-02-2010, 01:04 AM	#38
joshpjost Drives: Yaris 2008 Sedan Join Date: Jan 2010 Location: Amherst, MA Posts: 5	Thanks for the detailed response. To clarify: My switch is of configuration 1. The black wire is ground, because it has a eyelet, so I grounded it near the specified bolt near the clutch. According to your instructions, this black wire, (pin 1) should go to Conn D20 -Pin 2? For manual transmissions, is this Conn just laying near the stick below the console? Also, according to your instructions, it appears that I have the same configuration minus the ground. I have the red wire tapped into pin 4 of Conn D4 and the yellow wire tapped into Pin 3 - Conn D4. Would you agree that the misplacement of the black wire would cause my problem?