Daytime running lights ENABLE...

[ealbers]

I looked at your mod, very cool, but I'm not sure what I'd do to make the lights ON whenever the ignition is on,

I assume I'd hook the pink ignition wire to the relay coil to turn it on, then power ED in your diagram?? Where would I get the power from? Or would I just make ED connect to ground to turn the lights on??

Thanks!

[CTScott]

Originally Posted by ealbers

I looked at your mod, very cool, but I'm not sure what I'd do to make the lights ON whenever the ignition is on,

I assume I'd hook the pink ignition wire to the relay coil to turn it on, then power ED in your diagram?? Where would I get the power from? Or would I just make ED connect to ground to turn the lights on??

Thanks!

To have it switch the headlights on automatically with the key, rather than off with the key, you'd switch HL (pin 8) to ED with a normally open contact, instead of ED to ED with a normally open contact. Also, since you won't need to worry about T1, you can use a DPST relay (like a standard automotive relay) instead of a DPDT one.

The only issue is that this switches on the low beam without the headlight stalk and if you switch to high beam both will be on. To make the low turn off when the high is on, you would use a second relay. The seconds relay's coil would connect to HU (pin 9) and ED. Then, you'd clip HL's wire and connect it through the normally open contacts of the relay.