GB- Push to Start , With SMART ENTRY

[CTScott]

Originally Posted by Kioshi

Will you be producing another RFID tag reader? I wouldn't mind going that route and having that added onto my car.

My ignition wires are so short from all the errors i went through with the alarm/module, I don't think i can fiddle around with removing and adding this one to it

Yes, my intention is to make the RFID reader an add-on for my existing module.

[1NZYaris1]

Originally Posted by CTScott

Yes, my intention is to make the RFID reader an add-on for my existing module.

When , before or after the the Yari Guage
any estimate on price .

[CTScott]

Originally Posted by 1NZYaris1

When , before or after the the Yari Guage
any estimate on price .

Before. This is actually a much easier bit of development than the YarGauge. Price is looking to be $100 for the PTS module with the RFID reader and 4 RFID key tags (two that are literally the size and thickness of a credit card and two keyfob tags). It would also require a PTS switch, which can typically be purchased for ~$79.

[1NZYaris1]

Originally Posted by CTScott

Before. This is actually a much easier bit of development than the YarGauge. Price is looking to be $100 for the PTS module with the RFID reader and 4 RFID key tags (two that are literally the size and thickness of a credit card and two keyfob tags). It would also require a PTS switch, which can typically be purchased for ~$79.

Will the modual read the Tach signal this time , lol.
i know i shouldn't stall the car , but i do lol

[CTScott]

Originally Posted by 1NZYaris1

Will the modual read the Tach signal this time , lol.
i know i shouldn't stall the car , but i do lol

Yes. The voltage measuring method of deciding if it's running is just not accurate enough.