 |
 |
|
|
09-22-2010, 07:45 PM
|
#25 |
|
Banned
Drives: 09 jetta tdi dsg Join Date: May 2010
Location: mary esther fl
Posts: 91
|
finally got the correct input seal in and I removed the trans to find the input shaft seal is INSIDE the transmission. I had to completely disassemble the entire transmission to replace the seal the job took me 7 hours I'm just glad we had the 4 different pullers needed to remove fifth gear and pull the input shaft bearing out to replace the seal. everyone needs to take a peak under their car to make sure your not leaking gear lube as well.
on a side note the trans is very easy to pull and you do not need to remove the subframe. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch shudder when setting off in 1st gear | BuildCode | DIY / Maintenance / Service | 87 | 06-17-2015 07:14 AM |
| Help Me Find The Right Clutch | RacerFreakXXX | Performance Modifications | 18 | 10-20-2010 05:20 PM |
| Restarting car after popping the clutch... | PaidTimeOff | General Yaris / Vitz Discussion | 21 | 02-26-2009 01:40 PM |
| Having clutch issues ? | hystria | DIY / Maintenance / Service | 10 | 08-22-2007 11:34 AM |
Threaded Mode