For Sale: Every single part off an 07 MT Liftback

[Mz3oh5]

No thanks, I found the exact base antenna for $20 online.

[CTScott]

Originally Posted by Mz3oh5

No thanks, I found the exact base antenna for $20 online.

That's a great price. Toyota charges over $200 for the antenna base.

[tooter]

Hey Scott,

I understand that the engine sold, but did the intake manifold sell along with it? I'm looking for one I can use to develop a tooter intake manifold spacer.

I stupidly sold the two I had and never believed that I would ever need them again!

Thanks,

Greg

[CTScott]

Originally Posted by tooter

Hey Scott,

I understand that the engine sold, but did the intake manifold sell along with it? I'm looking for one I can use to develop a tooter intake manifold spacer.

I stupidly sold the two I had and never believed that I would ever need them again!

Thanks,

Greg

I did sell the intake manifold, but I have an extra that is cracked the face of the runners, but is fine on the engine side. You can have it for the cost of shipping.

[tooter]

Originally Posted by CTScott

I did sell the intake manifold, but I have an extra that is cracked the face of the runners, but is fine on the engine side. You can have it for the cost of shipping.

Thanks for your offer, Scott.
Could you post a pic so I can see if the crack would prevent the engine from running right? I'm looking for one that would work well enough to do dyno runs.

Thanks,

Greg

[CTScott]

Originally Posted by tooter

Thanks for your offer, Scott.
Could you post a pic so I can see if the crack would prevent the engine from running right? I'm looking for one that would work well enough to do dyno runs.

Thanks,

Greg

Sure. I will zing you a picture when I get home this evening. I actually taped the crack to allow the engine to run fine, until I picked up a replacement one.

[CTScott]

Originally Posted by tooter

Thanks for your offer, Scott.
Could you post a pic so I can see if the crack would prevent the engine from running right? I'm looking for one that would work well enough to do dyno runs.

Thanks,

Greg

Here's a picture of the one I have on hand. It had a crack in the #1 runner from the radiator getting pushed against it. I drove it for a bit with electrical tape over the crack and then siliconed it for a more heat resistant seal. I drove it for a couple of weeks before finding a non cracked one.

Intake.jpg

[tooter]

Thanks for taking the time post a pic, Scott.
I'd take it if it was just for testing, but think I need to pass because if the prototype spacer dyno tests good numbers, I'll still need to get an intact intake manifold for the marketing pictures.

Greg