 |
 |
|
|
|
|
|
|
||||||||
| View Poll Results: Dumbest thing you have done to your Yar so far | |||
| Put a CB antenna on it |
   
|
1 | 50.00% |
| Put rims that look funky/gay/stupid on it |
  
|
1 | 50.00% |
| wreck it |
  
|
0 | 0% |
| let it sit outside in a hail storm |
  
|
1 | 50.00% |
| eyelashes |
  
|
0 | 0% |
| put cheap tires on |
  
|
0 | 0% |
| put off doing brakes then run into something |
|
0 | 0% |
| upgrade all performance items except brakes |
|
0 | 0% |
| let your friend/wife/husband drive it and they bruise it |
|
1 | 50.00% |
| other item not listed, come up with more questions in another poll on your own |
|
0 | 0% |
| Multiple Choice Poll. Voters: 2. You may not vote on this poll | |||
|
|
Thread Tools | Display Modes |
11-19-2014, 03:47 PM
|
#3 |
  
Drives: 2010 Yaris Sedan Join Date: Oct 2013
Location: the good Carolina
Posts: 173
|
I just bought an SWR meter from Radio Shack. It did not come with a cable. So, I am gonna order a cable from Amazon. So, the CB is not hooked at the moment, but will be by next week. (didn't want to hook it until I am zeroing my meter, then getting the best SWR possible. The meter is decent and will measure output as well. Too, I have to put the end on the firewire, but wanna refer the how to as well first. And lastly, the ground near my left rear tail light, I merely sanded the body, and stuck one of the two speaker wires in there for a quick simple ground. Gonna also solder an eye on the end of the 16 gauge speaker wires I am using for ground (2 together). So, mostly ready with a few tweaks. I gave notice here at Ford, and will not have a lift readily available for my use in December, that is why I did all the underneath stuff now. (I also ran a power wire in a conduit, front to back, for the trailer harness and otherwise) (Gonna have a power tap in the trunk for whatever) I will report back the SWR and the output.
__________________
2010 Yaris sedan, TRD CAT back (sport muffler only, really), OBX header (relocated front AF sensor to front pipe), OBX throttle plate spacer, K&N filter (in stock air box-for now), TRD struts and shocks, Mexico Rough Road Springs x 4, new Yota sway bar links front, slotted/drilled rotors and Maxx brakes front, Valvoline synthetic brake fluid, 3M undercoated, 16" Konig Feathers Michelin Pilot Sport AS 3 + Tires TRD rear sway bar, 4 GT Spec bars including: front strut brace 2 point, 4 point ladder brace, mid chassis brace and rear lower tie brace, rear hitch, [B] 
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stubby antenna in the car wash? | DebbyM46227 | In Car Entertainment + Electronics (audio / video / alarm) | 6 | 05-23-2014 08:32 PM |
| Replacing roof antenna. Need info on a plug. | 2005vitzRS | In Car Entertainment + Electronics (audio / video / alarm) | 3 | 03-13-2014 06:49 PM |
| Euro Style Antenna (Small Antenna) | Saity | Items for Sale by private party | 9 | 12-12-2009 09:23 PM |
| DIY: Installing XM Radio with SureConnect antenna adapter | The Marshall | DIY / Maintenance / Service | 0 | 07-11-2009 09:57 AM |
| car antenna question | mikenacarato | In Car Entertainment + Electronics (audio / video / alarm) | 6 | 12-12-2008 01:41 AM |
Threaded Mode