suggestion on mudflaps / splash guards for 2010 Yaris Sedan? - Toyota Yaris Forums

mrpj · 03-27-2018, 07:28 AM

It requires 2 x 2mm diameter holes drilling into the plastic of the bumper for the rear mudflaps, into which the supplied screws (Philips type head) are fitted. The positions are marked by small dimples in the plastic. There's also a trim clip (centre push pin type) to remove underneath, refitted through the mudflap to secure. Best to remove the rear wheel for drilling access.
The front are secured by two hex. head (10mm socket or spanner) screws, should be supplied. The holes are already there, I think, in the plastic wheel arch protector shield. So no drilling required.
Illustrative fitting instructions are supplied with the Toyota mudflaps. I would advise buying the genuine article.
Just be careful tightening into plastic.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW	VitzBoy	General Yaris / Vitz Discussion	7	09-20-2023 08:50 AM
Comparison Test: 2012 Toyota Yaris Vs. 2012 Toyota Prius c	Yar Is Word	Third Gen Yaris General Discussion	27	09-07-2012 12:37 AM
Like a PRIUS... BUY THE YARIS SEDAN......LOOK AT THIS>>>>	jay cobbs	General Yaris / Vitz Discussion	8	06-07-2012 02:44 PM
2007 Yaris Pricing Info !	YarisBueller	New YARIS Purchase Forum	104	06-24-2009 05:54 PM
yaris Advance Sedan	Rudeshady	Central and South America	14	06-25-2007 02:50 AM

03-27-2018, 07:28 AM	#4
mrpj View User's Garage Drives: 2014 Icon+ 1.33l Multidrive Join Date: Nov 2010 Location: Staffordshire Moorlands, UK Posts: 145	It requires 2 x 2mm diameter holes drilling into the plastic of the bumper for the rear mudflaps, into which the supplied screws (Philips type head) are fitted. The positions are marked by small dimples in the plastic. There's also a trim clip (centre push pin type) to remove underneath, refitted through the mudflap to secure. Best to remove the rear wheel for drilling access. The front are secured by two hex. head (10mm socket or spanner) screws, should be supplied. The holes are already there, I think, in the plastic wheel arch protector shield. So no drilling required. Illustrative fitting instructions are supplied with the Toyota mudflaps. I would advise buying the genuine article. Just be careful tightening into plastic.