3D Maxpider Kagu Floor Mats

[ern-diz]

Originally Posted by Dliverance

I got my 3D mats today. Hey fit great and look amazing but they interfere with my clutch pedal. My car wouldn’t start because the pedal wouldn’t go down enough to disengage the neutral safety switch. Anyone else have this problem?

Not at all. You obviously have the mat pushed as far back toward the rear of the vehicle as possible, right? Also, you're not placing the 3D mat over the factory carpet mats, are you?

[Dliverance]

Originally Posted by ern-diz

Not at all. You obviously have the mat pushed as far back toward the rear of the vehicle as possible, right? Also, you're not placing the 3D mat over the factory carpet mats, are you?

Its not over the original mat and I would imagine it’s in the proper place since the drivers mat has two locks that would locate it. I can get it to work but I REALLY have to press the pedal into the mat. I think I might have to trim the drivers mat.

[Runethecursed]

Originally Posted by Dliverance

Its not over the original mat and I would imagine it’s in the proper place since the drivers mat has two locks that would locate it. I can get it to work but I REALLY have to press the pedal into the mat. I think I might have to trim the drivers mat.

Pull up the carpet and cut out the foam under it... ;)

I put my wider pedals on and had the same issue with the clutch and the gas pedal till I did that... actually I removed the foam, but you get the idea