I didn't take any pics during the build (i'm a noob and got resin on everything, not good for cameras) but here are some after shots. I got greedy and shot for .8 cf which is more than enough for most 10"s and a few 12"s. Pretty sure you can even put 2 small box 10"s in there. I think you could go 30-40% smaller and still have enough volume for a 10" with polyfill. I had to ditch the side storage but I think you could easily do a small box and keep them. I made the side walls 7.5" tall so it would be 8.25" tall with the mdf face. This way it's flush with the back seat when the seat is dropped flat. The spare is placed a little off center in the car, but the box is exactly centered, that's why it probably looks off.
Ordered a 10" Pioneer TS-W256DVC off ebay for $71 shipped, can't wait till it gets here.
If I had to do it again I'd use duct tape and release agent as suggested above and get a roller to get the air bubbles out from the layers of fiberglass. Otherwise, it went ok.
05-20-2007, 12:11 PM
Similar Threads
Threaded Mode