What's your opinion on Exhaust Tips? - Page 3 - Toyota Yaris Forums

1NZYaris1 · 10-31-2008, 11:27 PM

Quote:

Originally Posted by kimona

Paint it black and it virtually disappears!

Majic

paint, i love

it

*kimona* · 11-02-2008, 10:37 AM

You need to clean the muffler first. Then, use heat paint specifically designed for that purpose. Your local auto parts store should have it, and I believe I saw some in Home Depot the other day.

The tip available at Walmart doesn't look like some cheapy crap. It's stainless steel and resonated, and actually looks very good!

IsLNdbOi · 11-02-2008, 06:06 PM

Is there a DIY for removing the muffler?

1NZYaris1 · 11-02-2008, 06:15 PM

theres no need to remove muffler, but if you want to it is only a matter of undoing ,
the bolts with springs on them , (the ones above the axle).
as for paint just tell them you are painting excaust tail,
hope this helps .

IsLNdbOi · 11-02-2008, 06:21 PM

Is this heat paint a spray paint? So it's safe to just spray paint the muffler w/o removing it?

PHXDEMON · 11-02-2008, 06:44 PM

Quote:

Originally Posted by IsLNdbOi

Is this heat paint a spray paint? So it's safe to just spray paint the muffler w/o removing it?

Remove the muffler don't half ass it (it takes like 5 minutes) Just get spray paint with ceramic in it. Go to any auto parts store and find black spray paint designed for engine blocks or brake calipers. Either will work fine.

*kimona* · 11-02-2008, 09:36 PM

http://www.duplicolor.com/products/engine.html

IsLNdbOi · 11-05-2008, 05:15 AM

Stopped by Wal-Mart and saw this $12 tip you guys mentioned. Looked pretty good, but it was too big, long and kinda heavy for my taste.

So, I went to Pep Boys and found another tip by the same company (Pilot Motorsports). The Wal-Mart tip is around 8.5" long and has a round, slanted tip. The one I got from Pep Boys is only 7" long and has a square, slanted tip. This tip cost around $27 though.

I have installed it already, but it was dark after I installed it so I'll post pics. of it installed later today when the sun is up. The slanted tip follows the rear bumper's curve nicely. I like this tip much better than that Valor / Toyota brand tip I got from my dealer for my '07 LB.

*kimona* · 11-05-2008, 10:41 AM

The Walmart tips are also by Pilot Motorsports. At 8 1/2", the round slanted tip is certainly not too long. Fit it tightly up against the muffler bracket and tighten. It will sit under the edge of the bumper by almost 2".

IsLNdbOi · 11-05-2008, 08:28 PM

Here it is on my Yaris:

It doesn't stick out at all. The entire tip is still under the bumper.

custom Lftback · 11-19-2008, 09:37 AM

Quote:

Originally Posted by kimona

There used to be a good thread on tips, and this was considered one of the favourites:

You can actually get it at Walmart for about $10. It's all stainless steel, resonated, and super easy to install. It fits the YarisHB perfectly without any modification, and it stays in place securely. I've had one on my car for more than 2 years.

http://www.jcwhitney.com/autoparts/I...D:100000186093

I went by wal-mart yesterday and found this tip, and I bought for $10 just like you said. lol. I put it on no problem and it looks great! Thanks kimona

Revsson · 11-19-2008, 01:12 PM

I hate Wal-Mart, but that does look like a nice tip.
Most of their things are from China. Where is this tip made?

11-02-2008, 06:06 PM	#39
IsLNdbOi Drives: Polar White - 5 Door '09 LB Join Date: Aug 2006 Location: Las Vegas, NV Posts: 1,285	Is there a DIY for removing the muffler? Last edited by IsLNdbOi; 11-05-2008 at 04:57 AM.

11-05-2008, 05:15 AM	#44
IsLNdbOi Drives: Polar White - 5 Door '09 LB Join Date: Aug 2006 Location: Las Vegas, NV Posts: 1,285	Stopped by Wal-Mart and saw this $12 tip you guys mentioned. Looked pretty good, but it was too big, long and kinda heavy for my taste. So, I went to Pep Boys and found another tip by the same company (Pilot Motorsports). The Wal-Mart tip is around 8.5" long and has a round, slanted tip. The one I got from Pep Boys is only 7" long and has a square, slanted tip. This tip cost around $27 though. I have installed it already, but it was dark after I installed it so I'll post pics. of it installed later today when the sun is up. The slanted tip follows the rear bumper's curve nicely. I like this tip much better than that Valor / Toyota brand tip I got from my dealer for my '07 LB. Last edited by IsLNdbOi; 11-05-2008 at 08:08 AM.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Installing Greddy TI-C Exhaust System	redyaris	DIY / Maintenance / Service	13	08-01-2009 05:05 AM
GReddy prototype = Free Exhaust!	Chris_Lum	California	30	02-27-2007 11:13 PM
Fujitsubo Exhaust!!	MC-BPT	Sponsors Classifieds Area	17	11-16-2006 11:36 AM
Exhaust tips Sedan Liftback	tomjasz	Cosmetic Modifications (Exterior/Interior)	25	08-14-2006 07:05 PM
Toyota Performance Exhaust for Yaris HB	bigsky2	Performance Modifications	16	06-02-2006 11:21 AM

11-02-2008, 10:37 AM	#38
kimona Super Moderator Drives: 2014 White VITZ Join Date: May 2007 Location: Huntington Bch, CA Posts: 4,938	You need to clean the muffler first. Then, use heat paint specifically designed for that purpose. Your local auto parts store should have it, and I believe I saw some in Home Depot the other day. The tip available at Walmart doesn't look like some cheapy crap. It's stainless steel and resonated, and actually looks very good!

11-02-2008, 06:15 PM	#40
1NZYaris1 View User's Garage Drives: Yaris Join Date: Oct 2008 Location: New Zealand Posts: 2,566	theres no need to remove muffler, but if you want to it is only a matter of undoing , the bolts with springs on them , (the ones above the axle). as for paint just tell them you are painting excaust tail, hope this helps .

11-02-2008, 06:21 PM	#41
IsLNdbOi Drives: Polar White - 5 Door '09 LB Join Date: Aug 2006 Location: Las Vegas, NV Posts: 1,285	Is this heat paint a spray paint? So it's safe to just spray paint the muffler w/o removing it?

11-02-2008, 09:36 PM	#43
kimona Super Moderator Drives: 2014 White VITZ Join Date: May 2007 Location: Huntington Bch, CA Posts: 4,938	http://www.duplicolor.com/products/engine.html

11-05-2008, 10:41 AM	#45
kimona Super Moderator Drives: 2014 White VITZ Join Date: May 2007 Location: Huntington Bch, CA Posts: 4,938	The Walmart tips are also by Pilot Motorsports. At 8 1/2", the round slanted tip is certainly not too long. Fit it tightly up against the muffler bracket and tighten. It will sit under the edge of the bumper by almost 2".

11-05-2008, 08:28 PM	#46
IsLNdbOi Drives: Polar White - 5 Door '09 LB Join Date: Aug 2006 Location: Las Vegas, NV Posts: 1,285	Here it is on my Yaris: It doesn't stick out at all. The entire tip is still under the bumper.

11-19-2008, 01:12 PM	#48
Revsson View User's Garage Drives: 2009 Meteorite Metallic LB MT Join Date: Oct 2008 Location: Southeast Wisconsin Posts: 810	I hate Wal-Mart, but that does look like a nice tip. Most of their things are from China. Where is this tip made?