Remote Start DIY Wiring Guide 2006-2010 Yaris

[CTScott]

Originally Posted by adam1981

4A is the top left harness on that main panel behind the pull out pocket right?

All the wires match up except Green Pin 5 is Yellow on mine and There is nothing in Pin 20; there is a Blue in 19...

With the windows...do I have to have this additional module? The way my manual reads it will do auto-up without any additional modules... Can I just tap the Up Motor wires on that chart?

Also, something else I noticed, my horn is not sounding when it should with use of RS/Alarm. I tapped the wire under the column like your document said... It is negative switching right?

I need to get you a 6-pack for all this help!

Check the 4A wires relative to this:
Conn 4A 4B.jpg

For the windows, you can use those same wires if your system has the auto roll up feature. Just make sure that it is rated for high current (20+A) or else you will need relays.

For the horn, the black wire on the spiral cable connector is definitely it, and it is definitely negative switched. Check your tap to make sure it bit all the way in.