Installed Rain Sensing Wipers Sensor

[toy_toronto]

Originally Posted by CTScott

Correct if you have factory DRLs. If you don't then the tails are the opposite polarity and you have to provide +12V to pin 10 (T1) instead of a ground to 13 (B1).

I do have factory DRLs however I disabled it, does this change anything? At any rate, I'll gather the relays/diodes I need and work on this sometime this week or next.

Can you kindly do one final review of what I'm about to do based on this diagram I created?

Many thanks again Scott


* Headlamp control status after low-light is detected by sensor -> Relays switch pin 13 (tail) and 8 (Low) to GND:




-toy