Micro Image Intake Manifold thread - Toyota Yaris Forums

tooter · 02-20-2013, 12:39 PM

Those dyno runs were as accurate a comparison as I could make. Each successive run reflected only one change at a time (first a manifold, and then a throttle body) with everything else exactly the same. +3/+1.5 is pretty good for a throttle body.

mazilla · 02-20-2013, 12:45 PM

Quote:

Originally Posted by tooter

Those dyno runs were as accurate a comparison as I could make. Each successive run reflected only one change at a time (first a manifold, and then a throttle body) with everything else exactly the same. +3/+1.5 is pretty good for a throttle body.

Especially when you consider the cost of the throttle body!

tooter · 02-20-2013, 12:51 PM

Yes.

And I just paid the going rate $125. That's pretty cheap power.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mid-West Chapter Micro Image Car Club	lilredrocket	Southwest	10	10-05-2009 02:06 PM
Turbo Manifold thread	Sabretooth	Forced Induction Forum	78	05-22-2009 07:52 AM
Yaris Intake Manifold	richardholdener	Performance Modifications	201	05-18-2009 12:58 PM
Intake Manifold Gasket?	Nexus1155	DIY / Maintenance / Service	6	11-18-2008 09:03 PM
Official Richard Holdener MID-RANGE Intake Manifold List	WolfWings	Performance Modifications	59	11-14-2008 12:26 AM

02-20-2013, 12:39 PM	#1
tooter play every day Drives: 2012 Yaris L 2dr 5sp Join Date: Apr 2012 Location: Los Angeles Posts: 1,962	Those dyno runs were as accurate a comparison as I could make. Each successive run reflected only one change at a time (first a manifold, and then a throttle body) with everything else exactly the same. +3/+1.5 is pretty good for a throttle body.

02-20-2013, 12:51 PM	#3
tooter play every day Drives: 2012 Yaris L 2dr 5sp Join Date: Apr 2012 Location: Los Angeles Posts: 1,962	Yes. And I just paid the going rate $125. That's pretty cheap power.