tooter's manifold adventure... - Toyota Yaris Forums

malibuguy · 03-30-2013, 10:19 AM

That tooter looks great! Your experimental one looks like a jelly fish :p

tooter · 03-30-2013, 05:15 PM

Quote:

Originally Posted by malibuguy

That tooter looks great! Your experimental one looks like a jelly fish :p

Sort of does. Maybe I should call it the "tooter squid"... although that name has negative connotations. It may end up earning the name squid after I get the dyno results!

tooter · 03-30-2013, 08:27 PM

Cut the rest of the plenum off so that I could get the Dremel into the runner ports better...

Also gound off all the overhanging welds, and stainless steel bead blasted everything. This evens out all the grinding marks and will make it much easier to see the shapes of the ports while I'm grinding the bell mouths.

Before grinding...

...and after.

03-30-2013, 10:19 AM	#1
malibuguy Obsessed with 1.5L Drives: '10 PW Yaris Sedan Join Date: Feb 2011 Location: Westminster, MD Posts: 908	That tooter looks great! Your experimental one looks like a jelly fish :p __________________ -Greg...the Exhaust Freak. -10 PW sedan 107whp/110wtq, full exhaust, suspension bits, TRD LSD -06 Highlander 3mzfe Limited AWD -82 Malibu, 1uzfe swap -97 Tercel coupe, 1nzfe/4.31 -96 Tercel coupe, Turbo 5efe, autoX -96 Tercel 4dr

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
homemade intake manifold	ttr125fan09	Performance Modifications	1	02-17-2012 01:09 AM
Custom Intake Manifold + Direct Port Nitrous	blacksandiegovitz	Performance Modifications	9	04-21-2010 07:05 PM
Turbo Manifold thread	Sabretooth	Forced Induction Forum	78	05-22-2009 06:52 AM
turbo manifold build...	joey1320	Forced Induction Forum	4	06-30-2007 02:26 PM

03-30-2013, 08:27 PM	#3
tooter play every day Drives: 2012 Yaris L 2dr 5sp Join Date: Apr 2012 Location: Los Angeles Posts: 1,962	Cut the rest of the plenum off so that I could get the Dremel into the runner ports better... Also gound off all the overhanging welds, and stainless steel bead blasted everything. This evens out all the grinding marks and will make it much easier to see the shapes of the ports while I'm grinding the bell mouths. Before grinding... ...and after.