Front Sway Bar - Page 2 - Toyota Yaris Forums

Neinris · 01-30-2021, 11:05 PM

Quote:

Originally Posted by ElMagnifico

Yes. there is a whole thread dedicated to it.
https://www.yarisworld.com/forums/sh...ad.php?t=23911...

Yup, and if you look I was the last one who posted there.

Quote:

Originally Posted by ghowey

I am not dropping mine, the Yaris handles pretty well from the Factory, the rear TRD bar did improve stability/cornering a good bit. I am going for a Stock Look, after all my Sedan is a Daily Driver. However, I am investigating the 2ZR-FE engine swap. Looking at the possibility of having the correct VIN in the ECU, and keep the ignition inhibitor in place!

Too bad you're not dropping your car, it's the first thing I did, and it reduced body roll fairly significantly. I dropped mine with Teins lowering springs, and it's still very daily drivable.

ghowey · 01-31-2021, 11:45 AM

Perfect! Thanks!

Neinris · 04-15-2021, 12:32 PM

I forgot to reply to this. I measured the Yaris' front sway bar at 23mm, and the Scion xD at 25mm. I haven't replaced my sway bar yet, it's a PITA because you'd have to remove the subframe. It's better to do it when replacing the engine. Not sure if the xA's sway bar will fit, in case you want something just slightly stiffer, I measured one at 24mm.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3rd gen front sway bar	m.flores.0928	Third Gen Yaris General Discussion	8	05-17-2017 12:09 PM
xA or xD front sway bar fit in to 07 Yaris	yariseggvvti	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	1	10-29-2012 10:47 PM
My Ultra Racing rear sway bar install	CtrlAltDefeat	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	49	03-03-2011 03:08 AM
C-One Front Sway and 4 Point H-Brace ... SoCal	DuckinOut	Items for Sale by private party	3	09-13-2010 05:38 PM
C-One Front Sway Bar	Jerkratt	Wheels, Tires and Suspension Forum sponsored by The Tire Rack	23	06-29-2007 11:33 PM

01-31-2021, 11:45 AM	#20
ghowey Drives: 2010 Yaris Sedan Join Date: Mar 2018 Location: US Posts: 21	Perfect! Thanks!

04-15-2021, 12:32 PM	#21
Neinris View User's Garage Drives: 08 Yaris 3 Door Hatchback Join Date: Aug 2019 Location: ‘Murica! Posts: 461	I forgot to reply to this. I measured the Yaris' front sway bar at 23mm, and the Scion xD at 25mm. I haven't replaced my sway bar yet, it's a PITA because you'd have to remove the subframe. It's better to do it when replacing the engine. Not sure if the xA's sway bar will fit, in case you want something just slightly stiffer, I measured one at 24mm.