|
05-18-2009, 09:16 PM | #19 | ||
Start another Oil Thread!
|
Quote:
__________________
Quote:
|
||
05-18-2009, 10:29 PM | #20 |
Drives: Yaris LB Turbo Join Date: Aug 2006
Location: Miami FL
Posts: 782
|
There is a difference between cheap (your turbo kit) & buying a product that cost less (AEM vs Emanage) that will give you the same results if not better
|
05-18-2009, 10:33 PM | #21 | ||
Start another Oil Thread!
|
Quote:
so why doesn't yours work?
__________________
Quote:
|
||
05-18-2009, 10:39 PM | #22 |
Drives: Yaris LB Turbo Join Date: Aug 2006
Location: Miami FL
Posts: 782
|
Once again reading skills, it works, I can adjust fuel & timimg, you want to meet up so I can show you? Be at the Toyota meet on the 24th, at Dave & Busters
|
05-18-2009, 10:41 PM | #23 | ||
Start another Oil Thread!
|
Quote:
it works but you have serious CEL issues and the car runs like shit.
__________________
Quote:
|
||
05-18-2009, 10:43 PM | #24 |
Drives: Yaris LB Turbo Join Date: Aug 2006
Location: Miami FL
Posts: 782
|
Once again, reading skills, you need to work on that, yes I have a CEL, the car runs fine, if you want Ill take you foar a ride on the 24th......
|
05-18-2009, 10:57 PM | #25 | |
Start another Oil Thread!
|
you're not modifying the signals, you're driving around with blank maps.
you might as well just install the jumper cable that came with the FIC
__________________
Quote:
|
|
05-19-2009, 06:54 AM | #26 |
Drives: Vios Join Date: Oct 2008
Location: Brunei
Posts: 82
|
did u use the yaris wiring diagram that is sent u? is it any help?
|
05-19-2009, 07:12 AM | #27 |
Drives: Yaris LB Turbo Join Date: Aug 2006
Location: Miami FL
Posts: 782
|
1NZ: I tried but I could not read what you sent, when you scan them they came out to small, if you could try to scan them again that would be great.
|
08-03-2009, 06:27 AM | #28 |
any updates on this?
__________________
454 whp, 1.7 bar boost, pump gas, water/meth. 501 whp, 2.2 bar boost, pump gas + avgas, no water/meth. www.viosturbo.com - World's first 500 WHP 1NZ-FE |
|
08-03-2009, 07:47 AM | #29 |
ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
I just noticed this thanks to its bump. The primary 02 sensor is not a raw 0 to 1 volt output, like most 02 sensors (including the secondary on the Yaris). The primary output sits on a offset voltage from the ECM, so in order to tap into it your devices needs to be able to deal with the floated voltage and if your device uses the sensor data directly, and then fools the ECM with an output, its output needs to be able to deal with that offset.
|
08-03-2009, 12:25 PM | #30 | |
Drives: 2006 Mazda3 Sedan Join Date: Jun 2007
Location: Germantown, MD
Posts: 116
|
Quote:
__________________
|
|
08-03-2009, 12:54 PM | #31 | |
ULTIMATE
Drives: 09 5dr LB, 2x 08 3dr LB Join Date: Oct 2008
Location: USA, CT
Posts: 13,460
|
Quote:
Or, you could ignore the power pin going from the ECM to the sensor, feed the FIC output into a level shifter (using an op-amp) and into the ECM's input pin. |
|
08-03-2009, 01:07 PM | #32 |
Who said Yaris was slow?
|
Update from Boomslang:
For the Yaris, we already have the connnectors and are waiting for the tooling. ETA Aug-17 |
12-06-2009, 01:58 AM | #33 |
Drives: 07 Yaris RS 3dr Join Date: May 2009
Location: Winnipeg
Posts: 34
|
Any word from Boomslang?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
NEWS: TOYOTA REVEALS ALL-NEW YARIS SEDAN AT 2006 LOS ANGELES AUTO SHOW | VitzBoy | General Yaris / Vitz Discussion | 7 | 09-20-2023 07:50 AM |
AEM cold air intake vs Afe intake... | djgab101 | Performance Modifications | 69 | 04-28-2013 02:03 PM |
2007 Yaris Pricing Info ! | YarisBueller | New YARIS Purchase Forum | 104 | 06-24-2009 04:54 PM |
is the yaris for me? | sauruman | New YARIS Purchase Forum | 14 | 02-27-2006 08:27 PM |