 |
 |
|
|
05-18-2010, 11:17 AM
|
#5 |
|
1NZ-6spd
Drives: '05 6-Spd Vitz RS Join Date: Oct 2008
Location: Oshawa, Ontario, Canada
Posts: 2,967
|
If you guys did all the bending yourself, you should have built it a lot wider and higher. There's too much crush area between the body and the cage to be as effective as a roll bar should be.
In the event of a side impact, the car would crush into the seat before it hits the bar. Same applies in a roll over. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tamago's guide to ultimate yaris handling | Tamago | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 98 | 02-18-2024 06:45 AM |
| Ultra Racing 23mm Rear Stabilizer Bar | Loren | Performance Modifications | 62 | 05-18-2009 08:20 PM |
| solid torsion bar bushings... the best rear anti roll upgrade | turboyaris | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 28 | 12-06-2008 12:37 AM |
| Installed the Tanabe Strut bar but had to remove my ground wire kit.. | vacantj | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 6 | 10-01-2007 02:56 PM |
| Installed TRD Strut + Sway bar | Blenjar | Wheels, Tires and Suspension Forum sponsored by The Tire Rack | 21 | 07-11-2007 12:46 AM |
Threaded Mode