Rear wheel brakes adjustment ?

[Exiwolfman]

Hum noise sounds like bearing going if not and u find that bearings are fine and u have disk rear , make sure the pin sliders move free also pads ..clean the are lube/grease sliders all should move free same with piston .
As for drums , clean and adjust remove any rust of drum and so on .

sent from my S4 on Mars

[nookandcrannycar]

Originally Posted by Exiwolfman

Hum noise sounds like bearing going if not and u find that bearings are fine and u have disk rear , make sure the pin sliders move free also pads ..clean the are lube/grease sliders all should move free same with piston .
As for drums , clean and adjust remove any rust of drum and so on .

sent from my S4 on Mars

^^^^^ Info added by an expert . Fortunately, I haven't had the pleasure off rear wheel bearings going out on any car. The fronts I had go out on my Yaris = a hum and another sound that were both cleared up by replacing the bearings.