2012 Fog relay

[CTScott]

Originally Posted by Eforno

I didn't know a t-tap/scotch lock can just combine 2 wires together without one end of a wire cut off. Or did you mean like stripping the middle of each wire and that twisting them together? And if I were to wire my fog lights this way, the fogs likes will be on & off with respect to my DRL, Low Beam, and Hi-Beam being on & off?


I was actually planning to just use the four wire switch that comes with the fog light kit. So should the install be something like what I thought of before:


Thanks once again for the prompt reply! And I'm really sorry if it seems like I'm sounding too dense, I just want to make sure everything is correct before I start the install.

Some are capped on one end for one wire, but most are open on both ends allowing tapping of two wires without cutting either.



If the kit was aftermarket you will likely not be able to use the switch, as the aftermarket foglight kits have internal circuitry which bridges the switching and illumination circuits. The OEM switch does not do this, so you would either need to modify the aftermarket switch or use a generic switch.