My 2zrfe swap

[tmontague]

where are you guys finding the rpm package listed? I'm struggling to find the proper set up on line anywhere

[brushforhire]

Originally Posted by tmontague

where are you guys finding the rpm package listed? I'm struggling to find the proper set up on line anywhere

You can find the Scion XD RPM setup here: fastscions.

The only make it for the 2zrfe, if you were searching for the 1nzfe, that might be why you are having trouble finding it.

I got the axles popped out, but left them in the knuckles because the axle nuts were so rusted up. I have the struts off, so at least they have a bit of wiggle room.

So all I gotta do is unhook the fuel rail connector, and undo the three mounts and I should be good to take the engine out.

I am planning to lift it by the outer two mounts.

I removed the lower tie bar also for more room.

I am thinking I just might fab up a midpipe myself. I am so torn, I was kicking around getting the OBX catless system and welding in a new flange and cat, but it is stainless, and I don't know how tricky stainless to mild steel would be to weld.