need help: foglight indicator - where are the wires?

[jcboy]

Originally Posted by CTScott

You will either need to measure the switch wires with a volt meter to see which one goes from 0 to 12 volts when the switch is pressed (if any actually does) or you can connect to the wire on the other side of the relay, which actually brings the 12 volts to the fog light bulbs.

ok i did what you said, and connected the yellow wire, D2-7, and i also measured the blue wire on the fog switch, it actually gives 12V to when foglights get switched on. it didnt work. both the green wires gave 12V when the park light switch was turned on, it also didnt work in firing up the foglight indicator on the gauge. is it possible to have indicators in the cluster but no LED for that?

BTW, the factory-wired esuse foglamp was included in the harness. the wires the arrow point to come from the switch and are attached to the harness (thick one, in the middle) and somehow finds it way toward the relay (blue Denso relay on the right side, encircled) and also to the outside fusebox (probably)/engine bay, so there's really no route for me toward the esuse fog light install instructions.

FYI, the items on the relays, etc, either say Denso Made in Japan or Denso Made in Thailand. So it gets even worse knowing my VIN tag says Made in Philippines. Now we dont know if the wiring follows the other Toyota plants and which one if it does.. Help...

[CTScott]

Originally Posted by jcboy

ok i did what you said, and connected the yellow wire, D2-7, and i also measured the blue wire on the fog switch, it actually gives 12V to when foglights get switched on. it didnt work. both the green wires gave 12V when the park light switch was turned on, it also didnt work in firing up the foglight indicator on the gauge. is it possible to have indicators in the cluster but no LED for that?

BTW, the factory-wired esuse foglamp was included in the harness. the wires the arrow point to come from the switch and are attached to the harness (thick one, in the middle) and somehow finds it way toward the relay (blue Denso relay on the right side, encircled) and also to the outside fusebox (probably)/engine bay, so there's really no route for me toward the esuse fog light install instructions.

FYI, the items on the relays, etc, either say Denso Made in Japan or Denso Made in Thailand. So it gets even worse knowing my VIN tag says Made in Philippines. Now we dont know if the wiring follows the other Toyota plants and which one if it does.. Help...

That is interesting that the Esuse fogs are actually wired through the OEM fog wiring, rather than with the Esuse aftermarket harness. The presence of the blue relay on the right tells me that the foglight indicator is already hooked up, so it does appear that it is not active on your cluster.