Blitz SuperCharger Install

[cali yaris]

Would the s/c guys go for an overdrive pulley? Is there room? Someone measure for that.

[kurokoma-kun]

Originally Posted by cali yaris

Would the s/c guys go for an overdrive pulley? Is there room? Someone measure for that.

How interesting, I was just discussing this with someone else.

How much enlargement is needed to see the benefit? I've seen overdrive pullies for the Mini that are just +2%...

There's less than a finger's width of clearance between crank and w/p pullies on the yaris--don't think that's enough?

I use my stock crank pulley as a paperweight however, I'll measure it tonight

[NonStopTuning]

Originally Posted by kurokoma-kun

How interesting, I was just discussing this with someone else.

How much enlargement is needed to see the benefit? I've seen overdrive pullies for the Mini that are just +2%...

There's less than a finger's width of clearance between crank and w/p pullies on the yaris--don't think that's enough?

I use my stock crank pulley as a paperweight however, I'll measure it tonight

Garm and I have chatted about this a couple times. And where there is a will, there is always a way. We have worked around such limitations in other SC Toyotas in the past. Think late 80s Toyota MR2 SC.

The dilemma we have has been the same one we have had since day one. We need someone with a SC Yaris, with the ability and willingness to test a pulley for us, and get some extensive dyno data with the stock pulley and any test pulley we offer. We have not had any serious takers.

You all know my phone number, my screen name, and my Email address. I am ready to chat whenever you guys are.