Want to build costom turbo kit. Need advice from boosted guys!

[pimp my yaris]

OK yesterday I ordered Garms Turbo manafold off Micro Image and also a GT25 turbo from E-bay. I will see how it mounts up then I will start planing costom intercooler piping and downpipe routing. Also will need to measure for oil feed and return line. And what I will need to tap pan for retun line. Any sugestions for return line tap would be helpful.

Turbo specs. I think this turbo should spool quickly and be good for low boost application


TURBO SPEC:

gt25 internal wastegate turbo charger

Intake :2.5 inch
Outlet: 2 inch
Compressor trim: .42 ar
Compressor Wheel diameter: 60.05 /42.12
Turbine wheel diameter : 46.46 /53.20
Exhaust trim: .49ar
Turbine flange type: t25 flange
Downpipe flange type : 5 bolt type (will not fit sr20 down pipe bolt pattern)
Cooling type: oil and water cool
Actuator : set at 8psi
Horsepower rating: 250-300hp+
(wet float bearing)

1 YEAR WARRANTY IF INSTALLED BY PROFESSIONAL MECHANIC ( ASE CERTIFIED)


Turbo was $239.99 shipped to my door