need help: foglight indicator - where are the wires?

[CTScott]

Originally Posted by cyberfrogg

oooohhhhh! No, I didnt do that. I just inserted the wires with the existing ones. Blue into pin 3 and green to pin 4. Was I supposed to remove the existing wire in pin 3? what would that do?

The pin 4 connection is the big issue I believe. Only the OEM wire should be connected there.

Try this:

1. Disconnect both of your wires from Pins 3 and 4.

2. Pop the pin out of pin 3 (or, if your harness just has bare ends, snip the wire going to pin 3, leaving an inch or so to connect to.

3. Connect one of your wires to one side of the snipped wire (harness side) and the other to the other side (connector side).